5. Press "1" key on the remote control. The DVD Self-Diagnostic
Test function will start automatically.
Fig. 5-2
6. After a few minutes (approx. 1~5 minutes), the check results will
appear on the TV screen.
- If no error is detected, "COMPLETED" will appear as shown in
Fig. 5-3. Be sure to press Power OFF to end. Then, press
Power ON again and remove the DVD disc from the Tray.
Fig. 5-3
- If some error is detected, a 2-digit for Error Code will appear
as shown in Fig. 5-4.
Fig. 5-4
Fig. 5-5
11