15
Initial Setup
Reset all unit Memory Functions
When moving unit to a new location, or if a
mistake was made in the Initial Setup section.
• Make sure a tape is not inserted in the unit.
Manual Clock Set
If AUTO CLOCK SET was incomplete, manually
set the clock as follows.
1
2
Press ACTION on the Remote to
display SET CLOCK Menu screen.
Press to select the month
and press
manner, select and set the date,
year, time, and DST. (Daylight
Saving Time)
3
Press ACTION twice to start
CLOCK and exit.
3
1
2
dy to Play)
ET
WN
WN
Note to CABLE System Installer
This reminder is provided to call the
CABLE (Cable TV) System Installers
attention to Article 820-40 of the NEC
that provides guidelines for proper
grounding and, in particular, specifies
that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
Turn the unit
Power on.
Press and hold both PLAY and
FF on the unit for more than 5
seconds.
• The power will shut off.
•Please ignore “NO CASSETTE” warning.
*Important: If a remote control button does not work when pressed, pres
on the remote and try the button again.
SKIP
SET
:
SE
L
E
C
T
:
END
:
ACT
I
O
N
SET
C
L
OC
K
DST
:
O
N
SESE
LL
EE
CC
TT
MM
OO
NN
THTH
1 / /1 / /
::
SET
:
START
:
ACT
I
O
N
SET
C
L
OC
K
DST
:
O
N
SE
TT
COMPLETED
2 / 6/
::
2002
WED
12
00
PM
SET
BACK:
SET
SET to set. In the same
Do “Initial Setup” on page 14.
s the button
To Next Page
Loading...
