48
PC Connection
2
4
To PC Connector
PHOTOVU LINK Driver (Optional)
System Requirements for PHOTOVU LINK Driver
• IBM PC/AT or compatible
• Intel
Pentium
Processor
• Microsoft Windows
98/Me/2000/XP
• RAM: 16 MB or more
• 2 MB minimum available hard disk space
• 256 colour monitor (full colour
recommended)
• 3.5 inch 1.44 MB floppy disk drive
(for installation)
• RS-232C serial port (D-Sub 9-pin)
An adaptor (D-Sub 9-pin male to a
D-Sub female) is required for a
D-Sub 25-pin
• Mouse or other pointing device
RS-232C Serial port
(D-Sub 9-pin)
(Default is COM1.)
PC Connecting Cable for Windows
(optional: PC Connection Unit (PV-DRS2A, p. 51))
An image recorded on the DV Tape can be transferred to your PC (Personal Computer).
Connection
1 Turn off your PC.
2 Connect the Palmcorder to your PC (Windows) using the PC connecting cable
(optional: PC Connection Unit (PV-DRS2A, p. 51)).
• Before connecting the Palmcorder to the PC, make sure the PC
power is off to ensure that images are transferred properly.
3 Turn on your PC.
4 Set the Palmcorder POWER to VCR.
• For extended periods of use, it is recommended to use the AC Adaptor as a power
source.
• Refer to PC or Windows manual to identify which COM port is to be used for connection.
Note
*Satisfy the conditions recommended by Microsoft for Windows.
DV103-K.p47-50.p65 2003/06/11, 13:1948
To Next Page
Loading...
