Panasonic PV-GS250 - Using the Viewfinder; Power Supply

Before using
16
LSQT0862
Using the viewfinder
x Extending the viewfinder
1 Pull out the viewfinder and extend it by
pulling the extension knob.
x
Lifting up the viewfinder
1 Lift it up by pinching the viewfinder
extension knob.
x
Adjusting the field of view
1 Adjust the focus by sliding the eyepiece
corrector knob.
pYou can adjust the brightness of the viewfinder
from the menu.
Power supply
x Charging the battery
When this product is purchased, the battery is not
charged. Charge the battery before using this
product.
pBattery charging time (
-17-)
pWe recommend using Panasonic batteries.
pIf you use other batteries, we cannot guarantee
the quality of this product.
pIf the DC input lead is connected to the AC
adaptor, then the battery will not charge.
Remove the DC input lead from the AC adaptor.
1 Connect the AC cable to the AC adaptor and
the AC jack.
2 Put the battery on the battery mount by
aligning the mark, and then securely plug it
in.
x
Charging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged
(discharged excessively). In a while,
the lamp will light up and normal
charging will start.
When the battery temperature is
excessively high or low, the [CHARGE]
lamp flashes and the charging time will
be longer than normal.
12:30:45PM
OCT 15 2005
12:30:45PM
OCT 15 2005
12:30:45PM
OCT 15 2005
12:30:45PM
OCT 15 2005