Panasonic PV-GS250 - Recording Still Pictures on a Card While Recording Image Onto a Tape; Check the Recording; Blank Search Function

Record mode
29
LSQT0862
Recording still pictures on a card
while recording image onto a tape
You can record still pictures while recording
image onto a tape.
pSet to Tape Recording Mode.
1 Press the [PHOTO SHOT] button fully while
recording image onto a tape.
pFor the number of still pictures to be recorded
on a card, refer to
-80-.
pWhen recording pictures onto a card, the
recording start/stop button is disabled.
pYou can select a picture quality for still pictures
to be recorded. (
-31-)
pIn tape recording mode, the size of pictures that
can be recorded is [640].
pIn order to record higher quality still pictures,
you must use the card recording mode.
pIf the wide mode is used, you cannot record
images onto the card.
pThe [PHOTO SHOT] button does not work if it is
pressed halfway.
Check the recording
The last image recorded is played back for 2 to
3 seconds. After checking, the Camcorder will be
set to a recording pause.
pSet to Tape Recording Mode.
1 Press the joystick during the recording
pause until the icon  appears.
2 Move the joystick down to select the
recording check icon [ ].
Blank search function
Searches for the last part of the image recorded
(unused part of the tape).
pSet to Tape Recording/Playback Mode.
1 Set [BASIC] or [ADVANCE] >>
[BLANK SEARCH] >> [YES].
x
Stopping a blank search midway
through
Move the joystick down.
pIf the cassette tape has no blank part, then the
Camcorder will stop at the end of the tape.
pThe Camcorder stops at a point approx.
1 second before the end of the last image
recorded. When you start recording at that
point, the image can be recorded seamlessly
from the last image.
PHOTO
SHOT
