Record mode
32
LSQT0862
x To use the zoom microphone function
Interlocked with the zooming operation, the
microphone will clearly capture sounds far away
with the tele-shot or those in the vicinity with the
wide-angle shot.
pSet to Tape Recording Mode.
1 Set [ADVANCE] >> [ZOOM MIC] >> [ON].
x
About the variable speed zoom
function
pWhen pushing the [W/T] lever as far as it will go,
you can zoom from 1M to 10Min 1.0 second at
the maximum.
pThe zoom speed varies according to the amount
of movement of the [W/T] lever.
pFor the Magic Wire Remote Control with
Narration Mic, the zoom speed changes in
2 stages.
pThe variable speed zoom function cannot be
used with the remote control.
Recording yourself
You can record yourself while viewing the LCD
monitor. You can record persons in front of the
Camcorder while showing them the image. The
image is horizontally flipped as if you see a mirror
image. (The image to be recorded is the same as
that recording.)
1 Rotate the LCD monitor towards the lens
side.
pWhen the LCD monitor is opened, the
viewfinder will be automatically turned off. If the
LCD monitor is rotated towards the lens side
though, then the viewfinder will be activated.
pWhen the LCD monitor is rotated towards the
lens side, the icon will not be displayed even if
you push the center of the joystick.
Quick start
This Camcorder will be put into standby in
approx. 1.7 seconds after the power is turned on.
pThis is only activated in the following cases.
pA tape or a card is inserted, while the Tape
Recording Mode is set.
pA card is inserted, while the Card Recording
Mode is set.
1 Press the [QUICK START] button.
pThe quick start recording lamp lights up.
(Press the button again to cancel it.)
2 Set the [OFF/ON] switch to [OFF].
pThe quick start is now ready.
3 Set the [OFF/ON] switch to [ON].
p
This Camcorder will be put into a recording
pause in approx. 1.7 seconds after it is turned on.
x To cancel the quick start when the
power is [OFF]
Press and hold the [QUICK START] button for
approx. 2 seconds. The lamp will go off and the
Camcorder will be completely turned off.
pIf the standby continues for approx. 30 minutes,
then the lamp will go off and the Camcorder will
be completely turned off.
pWhen you rotate the mode dial or remove the
battery, the quick start recording lamp is turned
off and the quick start mode is canceled. If the
Camcorder is turned on and the Tape/Card
Recording Mode is set though, the lamp turns
on and the quick start mode is restored.
p
When the Camcorder is quick-started with the
white balance on automatic, it may take some
time until the white balance is adjusted if the
scene being recorded has a light source different
from the scene last recorded. (When the
MagicPix function is used, however, the white
balance of the scene last recorded is retained.)
pThe zoom magnification differs from when it is in
the quick start standby mode and when the
recording starts.
p
Since about half the power of normal recording is
used in quick start standby, using quick start reduces
the time during which pictures can be recorded.
ZOOM
START
QUICK
To Next Page
Loading...
