27
Recording Mode
2/2
To Check the Recording
You can play back the last few seconds of the
recorded scene in the Recording Pause Mode.
1 Press the Joystick Control
35
twice to
display the One-Touch Navigation icon on
the lower right of the screen.
[One-Touch Navigation icon]
2 Move the Joystick Control [▼]
35
to select
[ ].
• The [ ] indication is displayed. After checking,
the Camcorder resumes the Recording Pause
Mode.
35
Finding the End of Recording
( Blank Search Function)
• The [ ] indication and the One-Touch
Navigation icon appears during the Blank
Search.
• Approximately 1 second before the last recorded
scene, the Camcorder switches to the Recording
Pause Mode or the Still Playback Mode.
• If there is no blank left on the Cassette, the
Camcorder stops at the end of the tape.
The Blank Search Function aids you in locating the
end of the recording on the Cassette quickly (unused
part of the tape).
• Set to Tape Recording/Playback Mode.
1 Set [ BASIC] or [ ADVANCE] >> [
BLANK SEARCH] >> [YES].
35
30
SP 3h59m59s29f
R2:00
12:34:56AM
JAN 2 2005
To Cancel the Blank Search Function
Before Completion
Move the Joystick Control [▼] to select [ ].
2 Set the Mode Dial
34
to Card Recording
Mode.
3 Press the [PHOTO SHOT] Button
25
.
• The [ ] Indication lights up in red.
Recording a Still Picture on a Card
(Photoshot)
Still pictures can be recorded on the Memory Card
from the Camcorder.
34
25
When the [ ] Indication is displayed, Progressive
Photoshot Function works. You can record still
pictures with higher quality by using this function.
• The Progressive Photoshot Function may not be
activated depending on the function you use. (p. 64)
• To record still pictures with higher quality, we
recommend setting to the Card Recording Mode.
(To activate the Progressive Photoshot Function
regardless of the function you use)
• When you record onto the tape and the card
simultaneously, the Progressive Photoshot Function
is not activated.
Progressive Photoshot
1 Set the [OFF/ON] Switch
28
to [ON].
• The [POWER] Lamp
32
lights up.
28
32
To record still pictures clearly
• When zooming in on the subject with a magnification
of 4× to 10× or higher, it is difficult to reduce the
slight hand shaking from holding the Camcorder. We
recommend decreasing the zoom magnification and
approaching the subject when recording.
• When recording still pictures, hold the Camcorder
firmly with your hands and keep your arms stationary
at your side so as not to shake the Camcorder.
• You can record stable pictures without hand shaking
by using a tripod and the Remote Control. (PV-GS35
only)
To Next Page
Loading...
