29
Recording Mode
To brighten the natural colours in a scene. Gain Up
mode works with the Built-in Video Light to enhance
the light’s brightness.
• Set to Tape/Card Recording Mode.
1 Press the [LIGHT] Button
33
.
1
Recording with the Built-in LED
Video Light (For PV-GS31/PV-GS34/
PV-GS35)
2 Press the [LIGHT] Button.
2
• Gain Up mode is set to off.
• To eliminate ghost images, use this mode.
3 Press the [LIGHT] Button.
3
• The Video Light turns off.
• Pressing the [LIGHT] Button again returns to
1
.
1 2 3
• For other notes concerning this item, see page 66.
33
Quick Start
3 Set the [OFF/ON] Switch
28
to [ON].
• The Camcorder will be ready for recording
in approximately 1.3 seconds (PV-GS19) /
1.7 seconds (PV-GS31/PV-GS34/PV-GS35).
• For other notes concerning this item, see page 66.
To Cancel the Quick Start when the
Power is OFF
Keep the [QUICK START] Button pressed for
approximately 2 seconds and make sure the Quick
Start Recording Lamp is not lit.
2 Set the [OFF/ON] Switch
28
to [OFF].
• The Quick Start Recording Lamp remains lit.
29
28
This Camcorder will be put into standby in approx.
1.3 seconds (PV-GS19) / 1.7 seconds (PV-GS31/
PV-GS34/PV-GS35) after the power is turned on.
• This is only activated in the following cases:
- A tape or a card is inserted, while the Tape
Recording Mode is set.
- A card is inserted, while the Card Recording Mode
is set.
• Set to Tape/Card Recording Mode.
1 Press the [QUICK START] Button
29
.
• The Quick Start Recording Lamp
29
lights up.
(Press the button again to cancel it.)
Self-timer Recording
When you set the self-timer, the recording starts
automatically after 10 seconds on the Card.
• Set to Card Recording Mode.
1 Set [ BASIC] >> [ SELF TIMER] >> [YES].
• The [ ] Indication appears.
2 Press the [PHOTO SHOT] Button
25
.
35
30
• The [ ] Indication flashes and the recording
starts after 10 seconds. After recording, the
Self-Timer will be cancelled.
• If the RapidFire Consecutive Photoshot is set, the
maximum recordable pictures (max. 10 pictures) are
recorded. (p. 28)
• For other notes concerning this item, see page 66.
To Stop the Self-timer in Progress
Press the [MENU] Button
30
.
• The Built-in LED Video Light lights and the Gain
Up mode is set to on.
• Gain Up mode will be brighter than when only
the Video Light is on, however, ghost images
will appear.