65
Others
Notes and Hints
UNABLE TO A.DUB
(LP RECORDED):
Because the original recording
was in LP Mode,
audio dubbing cannot be performed.
UNABLE TO A.DUB:
You are attempting to perform audio dubbing on a
non-recorded tape.
COPY PROTECTED:
Images cannot be recorded correctly because the
medium is protected by a copy guard.
CARD ERROR:
The Card is not compatible with this Camcorder.
You are attempting to format a failed card.
It displays, when you attempt to insert the
incompatible card to Card Slot.
NO CARD:
No card is inserted.
CARD FULL:
Card does not have sufficient memory remaining.
Select Picture Playback Mode and delete
unnecessary files.
NO DATA:
There are
no recorded files on the card.
UNPLAYABLE CARD:
You are attempting to play back
data not
compatible with this Camcorder.
FILE LOCKED:
You are attempting to erase protected files.
CARD LOCKED:
The write protection switch on the SD Memory
Card is set to [LOCK].
CHANGE MODE TO USE USB:
The USB Cable is connected to the Camcorder in
Card Recording Mode.
CANCEL NIGHT VIEW MODE:
You are attempting to select an item other than
[OFF] in [
SCENE MODE] during MagicPix
Mode.
DISCONNECT USB CABLE:
You are attempting to turn the Mode Dial in PC
Mode
with the USB Cable connected to the
Camcorder.
You are attempting
to record pictures on a
Tape/Card with the USB Cable connected to the
Camcorder.
PC DOES NOT SUPPORT USB2.0:
The Camcorder is connected to a personal
computer that does not support USB2.0.
CAN NOT USE USB:
You are connecting the USB Cable with the DV
Cable connected in MotionDV Mode.
CHANGE TO MANUAL MODE:
You are attempting to select an item
other than
[OFF]
in [ SCENE MODE] when the [AUTO/
MANUAL/FOCUS] Switch is set to [AUTO].
CAN NOT OPERATE
(MOTION DV MODE
) (PV-GS35 Only):
You are attempting to change [ D.ZOOM]
setting during MotionDV Mode.
TURN OFF THE VIDEO LIGHT:
You are attempting to select an item in [
SCENE MODE] when Light is on.
Concerning the Power Supply
• When the Camcorder has been used for a long time,
the Camera body becomes warm, but this is not a
malfunction.
• If the [CHARGE] Lamp does not light up although
the Battery is attached to the AC Adaptor, detach the
Battery and reattach it.
Inserting/Removing the Cassette
• When inserting a previously recorded Cassette,
use the Blank Search Function (p. 27) to find the
position where you want to continue recording. If you
overwrite-record on a previously recorded cassette,
be sure to find the position where you want to
continue recording.
• If a new Cassette is inserted, rewind to the beginning
of the tape before starting recording.
• When inserting the cassette, make sure it faces in
the right direction and then push it in until it stops.
• When the Cassette Holder is in action, do not touch
anything except the [PUSH] mark.
• Close the Cassette Compartment Cover tightly.
• When closing the Cassette Compartment Cover,
do not get anything, such as a cable, caught in the
cover.
Alarm Sounds
• Set to Tape/Card Recording Mode.
When [ BEEP SOUND] on the [ SETUP] is set to
[ON], confirmation/alarm beeps are issued as follows.
1 Beep
• When you start recording
• When you turn on the power
2 Beeps
• When you pause recording
2 Beeps 4 times
• When a cassette with its erasure prevention tab
set to [SAVE] is inserted, condensation occurs,
and at other times. Check the sentence displayed
on the screen.
To Next Page
Loading...
