Panasonic PV-GS400 - Playback Mode; Playing Back Recorded Tape

Playback Mode
44
Playback Mode
Playing Back a Tape
The recorded scene can be played back
immediately after the recording.
1 Set the [OFF/ON] Switch (48) to [ON].
≥The [POWER] Lamp
(46) lights up.
2 Set the Mode Dial (44) to Tape Playback
Mode.
3 Press the [6] Button (21) to rewind the
tape.
≥Rewind the tape to the point where you want
to start playback.
≥When the tape reaches the beginning,
rewinding stops automatically.
4 Press the [1] Button (19) to start playback.
≥The [!] Indication appears.
≥If a cassette recorded with a copyright
protection signal is played back, the picture is
distorted by mosaic-like patterns.
To Stop Playback
Press the [∫] Button (20).
O
F
F
ON
POWER
(48)
(46)
PC
S
D
(44)
FADE
ENTER
STILL
(21)
FADE
ENTER
STILL
(19)
(20)
ENTER
STILL
FADE
ª Adjusting the Sound Volume
To adjust the volume, push the [`VOL/JOG_]
Lever
(51) to display the [VOLUME] Indication.
Push the [`VOL/JOG_] Lever towards [T] to
increase the volume or push the [`VOL/JOG_]
Lever towards [W] to decrease the volume. The
[VOLUME] Indication goes off after the
adjustment is finished.
To adjust the volume with the Remote Controller,
press the [T] or [W] Button to display the
[VOLUME] Indication. Press the [T] Button to
increase the volume or press the [W] Button to
decrease the volume. The [VOLUME] Indication
goes off after the adjustment is finished.
≥The sound volume cannot be adjusted using the
Remote Controller in Playback Zoom Mode.
(
-46-)
≥For other notes concerning this item, see
-79-.
Finding a Scene You Want to Play
Back
ª Cue/Review Playback
If the [5] Button (18) or [6] Button (21) is
pressed during Playback, it turns to Cue Playback
A or Review Playback B.
≥If the Button is held continuously, it turns to Cue
Playback or Review Playback until you release
it.
WT
VOL/JOG
(51)
FADE
ENTER
STILL
(21) (18)
A
B
PV-GS400Eng.book 44 ページ ２００４年６月４日 金曜日 午後３時１７分