Note:
While battery remains, the Error No. will be displayed again when
the power is switched off and on again. (Once the Battery is
removed or dead, Error No. will not remain in the memory.)
4.1.4. REMOVAL/INSTALLATION OF F.P.C. FROM NON ZIF (ZERO INSERTION
FORCE) CONNECTOR
Removal/Installation of F.P.C. from the Non ZIF (Zero Insertion Force) connector:
1. There are 2 types (Type A, Type B) of Non ZIF connectors.
2. To remove the F.P.C. from the Non ZIF connector, use the Plier for
Non ZIF Connector (LSVQ0028) to pull out the F.P.C. as shown.
The same Plier for Non ZIF Connector (LSVQ0028) should also be
used to install the F.P.C. to the Non ZIF Connector.
FIg. 3-1
15
To Next Page
Loading...
