consists of a Cylinder and a Main FPC Holder (Ref. No.2). However,
FPC Holder (Ref. No.2) is available separately as a replacement part.
4. The Infrared Remote Control Unit (Ref. No. 123) replacement part is
available as a complete assembly unit only. Do not try to disassemble
the Infrared Remote Control Unit.
5. FPC Holder (Ref. No. 2) is not reusable. If removed, install a new one.
10.1.3. Electrical Replacement Notes
1. Unless otherwise specified;
All resistors are in
, K = 1,000 , M = 1,000 k .
2. Abbreviation
RTL: Retention Time Limited
This indicates that the retention
time is limited for this item. After the
discontinuation of this item in
production, it will no longer be
available.
NR Non Repairable Board Ass’y
MGF CHIP: Metal Glaze Film Chip
C CHIP: Ceramic Chip
COMPLX
CMP:
Complex Component
W FLMPRF: Wirewound Flameproof
C.B.A.: Circuit Board Assembly
P.C.B.: Printed Circuit Board
E.S.D.: Electrostatically Sensitive Devices
3. When replacing 0 .resistor, a wire can be substituted for it.
4. Since the UHF/VHF TUNER/TV DEMODULATOR UNIT (Ref. No. 743)
has already been pre-adjusted at the factory, do not try to adjust the
UHF/VHF TUNER/TV DEMODULATOR UNIT. The UHF/VHF TUNER/TV
DEMODULATORUNIT replacement part is available as a complete
assembly unit only.
5. EEP ROM IC (IC6004), MAIN C.B.A. replacement note:
After replacing EEP ROM IC (IC6004) or MAIN C.B.A., be sure to
perform the “PG SHIFTER ADJUSTMENT” in Service Manual for R4-
Mechanism Chassis for PV-Model (Order No. MKE0401000C1).
10.2. MECHANICAL REPLACEMENT PARTS LIST
COMPARISON CHART OF MODELS & MARKS
22
To Next Page
Loading...
