Panasonic RP-BT10 - Talking on Your Cellphone

RQT8993
18 19
RQT8993
Talking on your cellphone
Registering the device pair
In order to establish the wireless connection between the receiver and Bluetooth cellphone, the receiver and
cellphone pair must be registered.
•
Operations involving the receiver
Press and hold the MIC button on the receiver for 2 seconds.
The receiver’s power is turned on, and its lamp (red) starts blinking slowly.
Press and hold the [–] button on the receiver for 6 seconds.
The lamp (red) starts blinking rapidly.
Caution: While the lamp (red) blinks rapidly (for about 60 seconds), register the pairing of the
receiver and Bluetooth cellphone. Repeat step if the lamp (red) starts blinking
slowly.
•
Operations involving the Bluetooth cellphone
Using your cellphone, conduct a Bluetooth device search.
Caution:
• A list of detected devices is displayed on the cellphone screen, and “RP-BT10R
Panasonic” is displayed for the receiver.
If “ RP-BT10R Panasonic ” is not displayed, repeat the procedure from step .
• If you are requested to input the pass key, input “0000.”
Notes: • For further details on conducting the Bluetooth device search, refer to the operating
instructions of your cellphone.
• Once the pairing has been registered, it need not be registered again.
• It may not be possible to register the pairing with some cellphones because they use
a different data transfer format.
Setting the pair
In order to establish the wireless connection between the receiver and Bluetooth cellphone, the receiver and
cellphone pair must first be registered.
Before operating the units, check the following points.
• Has the pairing of the receiver and cellphone you are about to use been registered? (Refer to page 18.)
Press and hold the MIC button on the receiver for 2 seconds.
The receiver’s power is turned on, and its lamp (red) starts blinking slowly.
Establish a “hands-free” connection by performing the Bluetooth
connection operation on your cellphone.
• When the pair setting is completed, the receiver’s lamp (blue) starts blinking
slowly.
• To establish pairing again after pairing has been released or the receiver’s
power was turned off, press the MIC button on the receiver once, then check the
connection with the cellphone.
Note:
• For further details on the Bluetooth connection operation, refer to the operating instructions of your cellphone.
Hands
-free
RQT8993-P(RP-BT10P)0613.indd18-19RQT8993-P(RP-BT10P)0613.indd18-19 2007/06/1310:25:372007/06/1310:25:37