RQT8993
22 23
RQT8993
Listening to music on your cellphone
Operating the receiver
Once the pairing is set, the music play functions of your
cellphone can be operated by remote control .
(Same as for iPod
®
: page 16)
Notes: • Some cellphones may cancel the pairing when
playback is stopped on the cellphone side while
listening to music.
•
For further details on the operations after receiving
a call while listening to music, refer to the operating
instructions of your cellphone.
Winding up an operation session
Disconnect the Bluetooth connection using your cellphone.
Note:
• For further details on disconnecting the Bluetooth connection, refer to the
operating instructions of your cellphone.
Press and hold the MIC button of the receiver for 6 seconds.
The receiver’s power is turned off, and its lamp (red) goes off.
List of lamp displays
Receiver
Lamp Device status Remarks
Lights (purple) Now charging
Off Charging completed
Lights alternately blue and red. Low battery charge Under operation
Off While power is off
Blinks slowly (red) While power is on (no pairing) Power turns off after 3 minutes.
Blinks rapidly (red) When pairing is being set (*1)
Blinks slowly (blue) When pairing is set successfully
Blinks slowly (blue) When an incoming call is received
Blinks slowly (blue) While talking
*1 If the device that is trying to be connected cannot be found, the lamp blinks rapidly for a maximum of 60 seconds
or so, after which it blinks slowly again.
Transmitter
Lamp Device status Remarks
Off While power is off
Blinks slowly (red) While power is on (no pairing) Power turns off after 3 minutes.
Blinks rapidly (red) When pairing is being set (*1)
Blinks slowly (blue) When pairing is set successfully
*1 If the device that is trying to be connected cannot be found, the lamp blinks rapidly for a maximum of 60 seconds
or so, after which it blinks slowly again.
xxxxxxx
ㄦ
MIC
RQT8993-P(RP-BT10P)0613.indd22-23RQT8993-P(RP-BT10P)0613.indd22-23 2007/06/1310:26:062007/06/1310:26:06
To Next Page
Loading...
