Panasonic RP-BT10 - Operating the Receiver

RQT8993
16 17
RQT8993
Listening to music on your iPod
®
Operating the receiver
As soon as the pairing has been set, the iPod
®
can be operated by remote control.
Play/pause : Each time this is pressed, the mode is
switched.
Next/Fast-forward : Press this once to skip to the next track;
Press and hold it down to fast-forward.
Previous/Rewind : Press this once to return to the beginning of
the previous track; Press and hold it down to
rewind.
Volume (up) : Use this to adjust the volume level in 16 steps.
Volume (down) : Use this to adjust the volume level in 16 steps.
• Some operations may not be supported depending on the player
you are using.
• When you pause operation using the receiver, the iPod
®
screen
flashes approximately every 20 seconds. This is to prevent the
power from automatically turning off, and it is not a malfunction.
• The earphone volume depends on the receiver side, so changing
the iPod
®
volume does not change the earphone volume.
• Even if you change the volume with the receiver, the iPod
®
volume
display does not change.
Winding up an operation session
Press and hold the MIC button on the receiver for 6 seconds.
The receiver’s power is turned off, the pairing setting is released, and the lamp
goes off.
• The iPod
®
’s power turns off automatically.
Lamp
OFF
If you also establish pairing with a Bluetooth cellphone, you can receive calls to
your Bluetooth cellphone while listening to music on your iPod
®
.
RQT8993-P(RP-BT10P)0613.indd16-17RQT8993-P(RP-BT10P)0613.indd16-17 2007/06/1310:25:232007/06/1310:25:23