Panasonic RX-2700 - Maintenance; Erasure of Recordings

we
ee
|
@When recording from a sound source connected to the
Microphone Jack, the sound being recorded can be monitored
through the Built-in Speaker or headphones.
To prevent feedback (howling) when recording through the Built-in
Microphone, the sound being recorded cannot be monitored
through the Built-in Speaker or headphones.
e@When recording through an external microphone, use head-
phones to monitor the sound.
If it is necessary to adjust the volume level of the sound being
monitored, do so by using the Volume Controls.
Note:
If external microphones are placed too close to the speaker in
this unit, feedback (howling) may be heard. If so, place the
microphones as far away from the speaker as possible, or
reduce the volume.
@ Erasure of Recordings
When recording, previously recorded signals on the tape will be
erased automatically.
MAINTENANCE —
Ee
The head assembly, capstan, and pressure roller are in constant
contact with the tape. If these parts are dirty, the sound quality will be
impaired. Periodically, clean these parts as shown.
1) Open the Cassette Compartment cover by depressing the Stop/
Eject Button.
Depress the Record Button while pushing the Erase-Prevention
Lever (see the figure) located inside the Cassette Compartment.
The Recording/Playback Head, Erase Head, Capstan and the
Pressure Roller can be seen. Clean them with a cotton swab, ora
piece of wood with a soft cloth wound around it.
2
~~
Notes:
elf the heads are extremely dirty, clean them with a soft cloth
dampened with a little alcohol.
®Do
not
bring
metal
articles
or
magnetic
material,
such
as
a
screwdriver,
near
the
head
assembly.
©Do
not
clean
the
plastic
cabinet
with
benzine
or
thinner.
Clean
it
with
a
solution
of
soap
and
water.