Panasonic RX-DT690 - Connecting the Speaker System; Attaching the Speakers; Detaching the Speakers

This
unit
can
be
used
as
a
one-piece
portable
stereo
system
or
a
three-piece
component
system,
by
attaching
or
detaching
the
speaker
system.
Before
attaching
or
detaching
the
Speakers,
be
sure
to
disconnect
the
speaker
cables
from
the
speaker
terminals.
Be
sure
to
press
[POWER]
to
turn
the
unit
off
before
connecting
or
disconnecting
the
speaker
cables.
Attaching
the
speakers
1.
Align
the
speaker
with
the
main
unit
as
shown
In
the
figure,
interlock
the
grooves
and
press
down.
2.
Connect
the
coloured
speaker
cables
to
the
same
coloured
terminals.
3.
When
using
the
unit
with
the
speakers
attached,
wind
the
speaker
cables
as
shown.
Since
a
strong
magnet
is
used
for
the
speaker,
keep
magnetized
*
commuter
Passes,
tickets
or
personal
credit
cards,
recorded
tapes,
watches,
etc.
away
from
the
speaker.
The
speaker
magnet
in
the
speaker
may
damage
them.
Detaching
the
speakers
Speaker
Release
Lever
1.
Unlock
the
speaker
release
levers
by
pulling
them
in
the
direction
shown
above,
and
slide
each
speaker
up.
2.
Connect
the
speaker
cables
to
the
speaker
terminals.