Panasonic S-200PE1E8A - Monitoring the Outdoor Unit Alarm History: Display of Outdoor Unit Alarm History; Settings Modes: Setting the Outdoor Unit EEPROM

6-7
6
6
6-5. Monitoring the Outdoor Unit Alarm History: Display of Outdoor Unit Alarm History
* Displays outdoor unit alarms only. Does not display indoor unit alarms.
* Check the indoor unit alarm histories separately using the indoor unit remote controllers or other control device.
<Operating procedure>
(1) Press and hold the button and buttonsimultaneouslyfor4secondsor
longer to change to outdoor unit alarm history mode.
Duringthealarmhistorydisplay,“ServiceCheck”islit.
The display and operations are the same as the monitoring of the alarm device
historythatisperformedusingtheunitremotecontroller.However,theoutdoor
unit address appears instead of the unit No.
↓
(2) Press the button and select the outdoor unit for alarm history monitoring.
↓
(3)Usethetemperaturesetting
and buttons to select the item code for the alarm history.
The display shows the address of the selected outdoor unit, the item code, and the alarm history (alarm data).
TheoutdoorunitaddressisdisplayedassystemXX-YY.
SystemXX=Outdoorunitsystemaddress
↓
  YY=Outdoorunitsub-busaddress
Theitemcodeisdisplayedas01–08.01indicatesthemostrecentalarm.
The alarm history is indicated by the alarm code. (If there have been no alarm codes, “
” is displayed.)
(4)Toclearthealarmhistory,pressthe
button. (The outdoor unit alarm history will be cleared.)
↓
(5)Toend,pressthe
button. The display returns to the normal remote controller display.
6-6. Settings Modes: Setting the Outdoor Unit EEPROM

Settingmode1
<Operating procedure>
(1) Press and hold the
button and button simultaneously for
4seconds or longer.
(2)Usethetemperaturesetting
and buttons to
change the item code. The item codes and setting data are
shown in the tableof“ListofItemCodes”onthenextpage.
(3)Usethetimertime
and buttons to change the setting
data.
Toconrmthechangedsettingdata,pressthe button.
(Atthistime,“Setting”stopsblinkingandremainslit.)
(4)Duringthismode,“Setting”isdisplayed,blinking.Theoutdoor
unitaddressdisplaysectiondisplays“ALL,”theitemcodeand
number (DN value in the table), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The display changes
betweentherst3digits(Fig.
A
)andthelast3digits(Fig.
B
).
Whentherst3digitsaredisplayed,thetoppointofthecolonis
lit.)
(5)Toendthesettingmode,pressthe button.
(3)
(1)
(4)
(2)
(5)
are displayed alternately.
Displayoffirst3digits
A
B
Displayoflast3digits
and
(Example shows displayof000001.)
A
B
(3)
(1)
(2)
(5)
(3)
(1)
(2)
(5)
Displayofrst3digits
Displayoflast3digits
are displayed alternately.
(Exampleshowsdisplayof000001.)
SM830194-04_Single_BigPAC.indb 7 2014/10/31 13:21:24