1-52
1
Reference diagram for snow-proof duct - 1
Space requirements for setting - (1)
The models of U-200PE1E8 / U-250PE1E8 with snow-proof duct
[Obstacle to the rear of unit]
[Obstacle to the front of unit]
z
Top is open:
(1)
Single-unit installation (2) Obstacles on both sides
(3) Multiple-unit installation (2 or more units)
z
Top is open:
(1)
Single-unit installation
(2) Multiple-unit installation (2 or more units)
z
Top is blocked by an obstacle:
(Both sides are open)
z
Top is blocked by an obstacle:
(Both sides are open)
Outdoor unit
A B C D E F G
U-200PE1E8 / U-250PE1E8
150 150 250* 200 250* 150 200
Outdoor unit
H I J
U-200PE1E8 / U-250PE1E8
500 250* 1000
Outdoor unit
M N
U-200PE1E8 / U-250PE1E8
500 300
Outdoor unit
K L
U-200PE1E8 / U-250PE1E8
500 150
1. In cases 2 and 3 the height of the obstacle
must be no taller than the height of the outdoor
unit.
2. The amount of space required for removing
the screw on the rear of the unit.If in case the
sufficient space for maintenance is ensured
on the rear of the outdoor unit, installation is
possible with the space of both sides of not less
than 150mm where marked with * mark.
Notes:
Min. B
or more
Min. C
or more
Min. A
or more
Min. D
or more
Min. E
or more
Min. G
or more
Min. F
or more
Min. E
or more
Min. E
or more
Min. K
or more
Min. L
or more
Min. H
or more
Min. I
or more
Min. I
or more
Min. J
or more
Min. M
or more
Min. N
or more
Unit: mm
The amount of space required for removing the
screw on the rear of the unit.
If in case the sufficient space for maintenance
is ensured on the rear of the outdoor unit,
installation is possible with the space of both
sides of not less than 150mm where marked with
* mark.
Note:
Unit : mm
Unit : mm
Unit : mm
Unit : mm
Sec1.indd 52 2014/11/07 10:28:03
To Next Page
Loading...
