9-7. Required Minimum Space for Installation and Service
The installation instructions that come with the indoor unit
describe how to use it in combination with the U-200PE1E8
and U-250PE1E8 outdoor units.
Please refer to the following when using it in combination
with the U-200PE1E8 and U-250PE1E8 outdoor units.
This air conditioner is usually installed above the ceiling so
that the indoor unit and ducts are not visible. Only the air
intake and air outlet ports are visible from below.
The minimum space for installation and service is shown in
Fig. 1-33.
1170
1100
5555
1200
1310
(600 600)
Unit: mm
Unit: mm
Fig. 1-33
Min. 600
(Space for
service)
(Suspension bolt pitch)
(Suspension bolt pitch)
Min. 700
(Space for
service)
Air suction
side
Refrigerant
tubing
Inspection
access
Electrical
component box
Min. 130
Min. 610
Drain port
Drain pan
Ceiling face
It is recommended that space be provided (600 × 600 mm) for checking and servicing the electrical system.
Fig. 1-34 shows the detailed dimensions of the indoor unit.
479
300
100
2
100
100
42
1428
1310
71
1100
51
964
9x100P=900
10x100P=1000
106
44
1070
1310
67
67
113
(236)
364364
1334
60
43320
100
50
178
23
209344
1222
41
Fig. 1-34
1
Refrigerant tubing joint
(liquid tube ø12.7 mm) (Flare nut)
2
Refrigerant tubing joint
(gas tube ø25.4 mm) (Brazing)
3
Power supply outlet
4
Drain port (O.D. 32 mm)
5
Duct connection for suction
6
Duct connection for discharge
28-ø3.5 (Holes all around)
26-ø3.5 (Holes all around)
1200 (Suspension bolt pitch)
4 - 37x12 (Hole for suspension bolt)
1170 (Suspension bolt pitch)
<Type E1>
3
4
1
2
5
6
Fig. 1-32