5-36
5
5-8. How to Remove the Electrical Component Box
Removing
1.Remove the front panel and inspection panel from the outdoor unit.
2.Remove all local wires connected to the electrical component box.
3.Remove the wires (temperature sensor, coils of every sort of valve, pressure switch, fan motor and wires for
connecting compressor) connected to the electrical component box in the unit.
4.Remove the fixture screws (
×
4) as shown in the diagram and remove the electrical component box.
NOTE:
Be sure to remove the upper left side screw marked by * in the diagram because that screw cannot be seen from
the front side.
Outdoor unit before removal of front panel
Electrical component box after removal
Fixture screws (×4) for electrical component box
Inspection panel
SM830277-00_大洋州向け R32シングル_TD&SM.indb 36 19/02/28 13:37:39
To Next Page
Loading...
