Panasonic S-22KA1E5 - Wired Remote Control Local Setting Mode

236
17.5 Wired Remote Control Local Setting Mode
• During unit off, press the TEST RUN button for 5 seconds to enter LOCAL MODE.
• Press Temperature Up / Down button to select Mode No.
• Press Timer SELECT button to enter setting mode.
• Press Timer Up / Down button to select setting value.
• Press Timer SET button to confirm the selection.
• Press TEST RUN button to exit LOCAL SETTING MODE. If no operation is performed for 30 seconds, exit
LOCAL SETTING MODE.
Mode
No.
Items Setting value
Individual
Setting
Note 1)
Setting
value
memory
terminal
Note 2)
00 Centralized control address 000 – 200: Address 0 – Address 200

I
01 Fan speed up 000: OFF 001: ON I
000: Execute Reset
(Level 0)
Nighttime low noise
001 – 003: Level 1 – Level 3
Nighttime low noise ON time 0:00 23.50 (10 minutes interval)
02
Nighttime low noise OFF time 0:00 23.50 (10 minutes interval)
R
000: Default control
001: 10 seconds fan sampling operation
03
Thermostat OFF
indoor fan control
002: Fixed fan speed operation

I
000: default Thermostat OFF point (D)
001: Cool = D+2°C, Heat = D-2°C
002: Cool = D+4°C, Heat = D-4°C
003: Cool = D-2°C, Heat = D+2°C
04
Thermostat OFF
point adjustment
004: Cool = D-4°C, Heat = D+4°C

I
000: Clear address
06 Outdoor unit address
001 – 199: Address 1 - Address 199

I
10 Group address reset 000: Non-processed 001: Execute Reset Note 3)
11 Thermistor selection 000: Non-processed 001: Remote control R
000: OFF
001: ON
(no-interlocking)
12 Ventilation unit control
002: ON
(OFF coupling)
003: ON
(ON/OFF coupling)
R
Note 1) Mark
 in the column of the “Individual setting” shows a setting item individually made for each connected
indoor unit.
Note 2) “R” represents remote control and I “indoor unit”.
Note 3) Start the setting from the setting value 000.
17.5.1 Fan Speed Up
• This control can increase the fan speed of indoor unit with DC motor.
• When enable, the HIGH fan speed setting at Remote Control, indoor unit fan tap changed from Hi to SHi.