Panasonic S-22KA1E5 - 10 Remote Control Operating Instructions; Wired Remote Control CZ-RT1

77
1
2 3 4
6
7
10
8
12
9
11
14 15 16 171819
5
13
20
21
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
10. Remote Control Operating Instructions
10.1 Wired remote control
CZ-RT1
Name and function of each part
REMOTE
The OFF/ON button cannot be used.
LOCAL
All wired remote control buttons can be used.
Timer/time setting display
Check display
Fan Speed display
Operation mode selection display
FILTER RESET display
Appear after the cumulative running time reaches
approximately 2,500 hours of operation.
Temperature setting display (16°C – 31°C)
Airflow direction setting display
OFF/ON button
Used to start and stop the operation.
FAN SPEED button
Used to select the fan speed of HI, MED, LO or
AUTO.
MODE button
Used to select operation mode of AUTO, HEAT,
FAN, COOL or DRY.
TEMP (UP/DOWN) button
Use to select the desired temperature.
AIR SWING (AUTO/MANUAL) button
Not applicable for Hide Away models.
FILTER RESET button
Press to reset the “FILTER RESET” display after washing the filter.
TEST RUN button*
VENTILATION button*
ECONOMY button
Function not available for this model.
ODOUR WASH button
Function not available for this model.
CHECK button
Press this button if the check display is flashing.
TIMER/CLOCK SET button
Use to set the timer operation and the current time.
OPERATION Indicator
Light ON when the unit in operation.
NOTES
z Buttons with * mark are not needed for normal operation. If one of these buttons is pressed by mistake, press the same button once again to
cancel the operation.
z When the power resumed after power failure, by default the unit will restart automatically with all previous setting preserved by the memory
function under AUTO RESTART function.