Panasonic S-22KA1E5 - Wireless Remote Control CZ-RWS1 - Heat Pump Models; CZ-RWC1 - Cooling Models

78
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
10.2 Wireless Remote Control
CZ-RWS1 – Heat Pump models / CZ-RWC1 – Cooling models
Name and Function of each part
Address number display
Operation mode selection display
Infrared Transmitter
Transmit the remote control signal.
Airflow direction setting display
Fan speed display
Temperature setting display (16°C – 31°C)
Timer/time setting display
Show the timer operation setting time or the current time.
TEMP (UP/DOWN) buttons
Use to select desired temperature.
FILTER RESET button
Press to turn OFF the “FILTER” indicator at the control panel.
FAN SPEED button
Use to select the fan speed of HIGH, MEDIUM, LOW and AUTO.
AC RESET button*
System reset.
SET button
Local setting function
ADDRESS button*
Use to change the address setting of indoor unit.
RC RESET button
Use to clear the remote control setting from memory.
TIMER/CLOCK SET buttons
Use to set timer operation and current time.
AIR SWING (AUTO/MANUAL) buttons
Not applicable for Hide Away models.
MODE button
Use to select operation mode of AUTO, HEAT, FAN, COOL or DRY. HEAT mode is not available for CZ-RWC1.
OFF/ON button
Use to start or stop the operation
NOTE
z Buttons with * mark are not needed for normal operation. If one of these buttons is pressed by mistake, press the same button once again to
cancel the operation.
z When the power resumed after power failure, by default the unit will restart automatically with all previous setting preserved by the memory
function under AUTO RESTART function.
1
2
3 4
6
7
10
8
12
9
1114
15
16
17
18
5
13