1
1-11-1-1-25
If you wish to change the selected indoor unit, follow the
step (2).
<Procedure of CZ-RTC4>
Stop the system before performing these steps.
Press and hold the
, and buttons
simultaneously for 4 seconds or longer.
If group control is in effect, press the
button to set.
At this time, the fan at the indoor unit begins and select
the address (unit No.) of the indoor unit operating.
Designate the item code “
” by adjusting the
Temperature Setting
/ buttons.
=91
=90
=92
=93
Electrical component box
Press the timer time / buttons to select the
desired setting data.
Flap position
1
2
3
4
5
* Setting data “ ”
Setting data Flap position during operation
Without separate setting
Swing
Move to position
1
and stay
Move to position
2
and stay
Move to position
3
and stay
Move to position
4
and stay
Move to position
5
and stay
NOTE
The flap swings during the operation under “Setting
the Flap Separately”.
At this time, the unselected flaps are moved to the
position
1
.
A
°
°
Press the button.
(The display stops blinking and remains lit, and setting is
completed.)
If you wish to change the selected indoor unit, follow the
step (2).
Press the
button to return to normal remote
controller display.
1
2
3
4
5
6
3
6 1
2
4
2
5
4
Unit no.
Detailed settings
Code no. Set data
ALL
20:30 (THU)
01
Sel. Next
0002
and restart?
E
NOYES
xit detailed settings
SM830283-00_欧州向け R32シングル36-71形TD&SM.indb 25 20/01/30 10:25:17
To Next Page
Loading...
