77
<Procedure of CZ-RTC5B>
1
Keep pressing the , and
buttons simultaneously for 4 or more seconds.
The “Maintenance func” screen appears on the
LCD display.
2
Press the or button to see each
menu.
If you wish to see the next screen instantly, press
the or button.
Select “9. Auto address” on the LCD display and
press the button.
3
The “Auto address” screen appears on the LCD
display.
Change the “Code no.” to “A1” by pressing the
or button.
4
Select the “O/D unit no.” by pressing the or
button.
Select one of the “O/D unit no.” for auto address by
pressing the or button. Then press
the button.
Approximately about 10 minutes are required.
When auto address setting is completed, the units
return to normal stopped status.
1
Keep pressing the , and
buttons simultaneously for 4 or more seconds.
The “Maintenance func” screen appears on the
LCD display.
2
Press the or button to see each
menu.
If you wish to see the next screen instantly, press
the or button.
Select “7. Simple settings” on the LCD display and
press the button.
The “Simple settings” screen appears on the LCD
display.
Select the “Unit no.” by pressing the or
button for changes.
The indoor unit fan operates only at the selected
indoor unit.
Auto address setting
Checking indoor unit addresses
Maintenance func
Sel.
20:30 (THU)
Page [ ] Confirm
9. Auto address
10. Set elec. consumption
11. Set touch key
12. Check touch key
Auto address
Code no. O/D unit no.
20:30 (THU)
Sel. Next
1
A1
Fig. 7-11
CZ-RTC5B
20:30 (THU)
[ ]
START
Maintenance func
Sel.
20:30 (THU)
Page [ ] Confirm
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4. Test run
Maintenance func
Sel.
20:30 (THU)
Page [ ] Confirm
5. Sensor info.
6. Servicing check
7. Simple settings
8. Detailed settings
Simple settings
Unit no.
Code no. Set data
1-1 01 0001
20:30 (THU)
Sel. Next
7-20
SM830283-00_欧州向け R32シングル36-71形TD&SM.indb 20 20/01/28 11:22:25
To Next Page
Loading...
