14
Item Unit WH-ADC0309J3E5CM
Protection Device A Earth Leakage Circuit Breaker (30 ~ 40)
Expansion Vessel
Volume I 10
MWP bar 3
Capacity of Integrated Electric Heater / OLP TEMP kW / °C 3.00 / 80
Tank Volume (Spec / Nett) L 200 / 185
Max. Tank Water Set Temperature °C 65
Tank Coil Surface m
2
1.8
Maximum Working
Pressure
Space Heat Bar 3.0
Tank Circuit Bar 8.0
Operating Pressure
Tank Unit Bar 3.5
Expansion Relief Valve Bar 8.0
Expansion Vessel Pre-charge Pressure (DHW Circuit) Bar 3.5
Pressure Reducing Valve Set Pressure (DHW Circuit) Bar 3.5
Item Unit Indoor Unit
Pressure Vessel
Material En-1.4521
Volume L 185
Design Pressure Bar 10
Heat Exchanger
Material EN-1.4521
Diameter mm 22
Thickness mm 0.8
Surface Area m
2
1.8
Total Length m 25
Note:
In case it is necessary to indicate the air flow volume in (I/s), the value in (m
3
/min.) shall be multiplied by 16.7 and
rounded down the decimal point.
If the EUROVENT Certified models can be operated under the “extra-low” temperature condition, -7°C DB and
-8°C WB temperature with rated voltage 230V shall be used.
Capacity is measured at outdoor temperature 7°C DB and 6°C WB with controlled water inlet 30°C and water
outlet 35°C (EN 14511-2)
Flowrate indicated are based on nominal capacity adjustment of leaving water temperature (LWT) 35°C and
∆T=5°C.
EER and COP classification is at 230V only in occordance with EU directive 2003/32/EC.
* Above 55°C, only possible with backup heater operation.
To Next Page
Loading...
