Slide 80
From the previous page
YesNo
Does the TV
shut down
with 7 blinks?
B – From the previous slide
See the picture “A” on the previous slide and:
• Remove the 2 or 4 VFG screws from the SU and SD
boards.
• UnplugSC41, SC42, and SC46 from the SC board.
• Install the SC50 Jig (TZSC09187)or just jump pins 1
and 2 of connector SC50 on the SC board.
• Plug in the TV. Note: If the power LED does not
turn on automatically after the TV is plugged in
as expected, then press the power switch.
Replace the
SU and SD
boards
Replace the
SC, SU, and
SD boards
Unplug SD42 from the SD board and
perform the same resistance test.
YesNo
Is there a
short
circuit?
Replace the
SC and SU
boards
(4 of 4)
To Next Page
Loading...
