Panasonic SA-HT640WP - Disassembling the Rear Panel; Disassembling the Mechanism Base Assembly; Disassembling the FL & Head phone P.C.B.; Disassembling the Main P.C.B.

10.6. Disassembling the Rear Panel
· Follow (Step 1) to (Step 2) of Item 10.3.
Step 1 Remove 7 screws.
Step 2 Detach the FFC cable from connector (CN5704).
Step 3 Release the claws of the rear panel in the directions.
Step 4 Remove the rear panel in the direction of arrow.
10.7. Disassembling the Mechanism
Base Assembly
· Follow (Step 1) to (Step 3) Item 10.5.
Step 1 Remove 2 screws on each side of the mechanism base
block.
Caution: Take note of the screw type used. During
assembling, use the correct screw type and at the correct
location.
Step 2 Remove the tab.
Step 3 Detach FFC cables at connectors (CN2005 & CN2001).
Step 4 Remove the mechanism base block.
10.8. Disassembling the FL & Head
phone P.C.B.
· Follow (Step 1) to (Step 7) Item 10.4.
Step 1 Remove 3 screws.
Step 2 Remove the panel angle.
Step 3 Remove 7 screws.
Step 4 Remove the FL & Head phone P.C.B.
10.9. Disassembling the Main P.C.B.
· Follow (Step 1) to (Step 4) of Item 10.6.
· Follow (Step 1) to (Step 4) of Item 10.7.
Step 1 Remove 3 screws and 2 screw covers.
Step 2 Detach the FFC cables from connectors (CN2011,
CN5701, CN5708).
Step 3 Remove the sheild plate.
Step 4 Remove the Main P.C.B.
39
SA-HT640WP / SA-HT640WPC