10.6. Disassembling the Rear Panel
·
Follow (Step 1) to (Step 2) of Item 10.3.
Step 1 Remove 9 screws.
Step 2 Detach the FFC cable from connector (CN5704).
Step 3 Release the claws of the rear panel in the directions.
Step 4 Remove the rear panel in the direction of arrow.
10.7. Disassembling the Mechanism
Base Assembly
·
Follow (Step 1) to (Step 3) of Item 10.5.
Step 1 Remove 2 screws on each side of the mechanism base
block.
Caution: Take note of the screw type used. During
assembling, use the correct screw type and at the correct
location.
Step 2 Detach FFC cable at connector (CN2005).
Step 3 Detach FFC cables at connectors ( FP8251 & FP8531).
Step 4 Remove the mechanism base block.
10.8. Disassembling the FL & Head
phone P.C.B.
·
Follow (Step 1) to (Step 7) of Item 10.4.
·
Disassembly of the panel angle. [(Step 1) to (Step 2) of the
following]
Step 1 Remove 3 screws.
Step 2 Remove the panel angle.
Step 3 Remove 7 screws.
35
SA-HT940P / SA-HT940PC
To Next Page
Loading...
