Panasonic SC-HC37GN - Page 89

89
Step 19 : Remove the Tuner Holder.
Step 20 : Remove 4 screws.
Step 21 : Release the 2P Cable Wire from the slots.
Caution : During assembling, dress the 2P Cable wire into
the slots.
Step 22 : Slightly lift up the Main P.C.B..
Step 23 : Remove the Main P.C.B. as shown.
Step 24 : Upset the Main P.C.B..
Step 25 : Place the Main P.C.B. (Side A) on the Insulating
Material.
Step 26 : Connect 2P wire at the connector (CN401) on the
Main P.C.B..