11
TQBJ2086
Bluetooth
®
connection
You can connect and play an audio device
wirelessly through Bluetooth
®
.
Preparation
• Switch on the main unit.
• Switch on the Bluetooth
®
feature of the device
and put the device near the system.
• Read the operating instructions of the device for
details.
█
Pairing a device
Preparation
If this system is connected to a Bluetooth
®
device,
disconnect it (~right).
1 Press [ -PAIRING].
If the “ ” indicator blinks quickly, continue with
step 3.
2 Press and hold [ -PAIRING] until the “ ”
indicator blinks quickly.
If the “ ” indicator blinks slowly, repeat this
step.
3 Select “SC-HTB258”, “SC-HTB250”,
“SC-HTB208” or “SC-HTB200” from the
Bluetooth
®
menu of the device.
The MAC address (e.g., 6C:5A:B5:B3:1D:0F)
may be shown before “SC-HTB258”,
“SC-HTB250”, “SC-HTB208” or “SC-HTB200”
is shown.
If prompted for a passkey, input “0000” or
“1234”.
Once the Bluetooth
®
device is connected, the
“ ” indicator stops blinking and lights up.
Note:
You can pair up to 8 devices with this system. If a 9th device is
paired, the device that has not been used for the longest time
will be replaced.
█
Connecting a paired device
Preparation
If this system is connected to a Bluetooth
®
device,
disconnect it (~right).
1 Press [ -PAIRING].
2 Select “SC-HTB258”, “SC-HTB250”,
“SC-HTB208” or “SC-HTB200” from the
Bluetooth
®
menu of the device.
█
Disconnecting a device
Press and hold [ -PAIRING] until the “ ”
indicator blinks slowly.
Note:
• This system can only connect to one device at a time.
• When “ ” is selected as the source, this system will
automatically try to connect to the last connected device.
• The Bluetooth
®
device will be disconnected when you select
another source.
Active subwoofer wireless connection
[HTB258] [HTB250]
Preparation
Switch on the main unit.
Check that the wireless link is activated.
WIRELESS LINK indicator
Lights up: The wireless link is activated.
Lights off: The wireless link is not activated.
Blinks: The active subwoofer is trying to activate
the wireless link with the main unit.
Note:
• The wireless link will be activated when the main unit and
the active subwoofer are both switched on.
• The I/D SET button is only used when the main unit is not
paired with the active subwoofer. (~16)
TQBJ2086_en.fm Page 11 Wednesday, December 27, 2017 2:30 PM
To Next Page
Loading...
