EasyManua.ls Logo

Panasonic SD/HDD SDR-H20 - Page 114

Panasonic SD/HDD SDR-H20
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Others
114
LSQT1190
The remote control does
not function.
Has the button-type battery of the remote control run out?
# Replace it with a new button-type battery. (l 19)
A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.
If you set [SETUP]>[DISPLAY]>[OFF], indications other than
warnings and date indications disappear.
Recording does not start
although power is
supplied to this unit.
Has the SD card’s write protect switch been set to LOCK?
# No recording is possible while the write protect switch is set to
LOCK. (l 22)
Is the memory of the HDD or card full?
# If the HDD or card has no more available memory, free up some
memory by deleting unnecessary scenes (l 66, 71) or use a
new card.
Is the unit set to the video recording mode or picture recording
mode?
# No recording is possible unless the mode dial is at or .
Is the card slot cover open?
# If the cover is open, this unit may not operate normally. Close the
card slot cover.
Recording starts but
stops immediately.
The playback picture
breaks up for a moment.
The unit is hot. Follow the messages on the display.
# To use the unit again, turn the unit off and leave it for a while.
The unit arbitrarily stops
recording.
Is the AGS function activated?
# Record in the normal horizontal position or set [AGS] to [OFF].
(l 40)
Can the SD card be used for motion picture recording?
# Use an SD card that can be used for motion picture recording.
(l 22)
The operation arbitrarily
stops.
The drop detection function has activated to protect the HDD.
# Do not drop or shake this unit while operating it.
Recording stops
suddenly during motion
picture recording on a
card.
When using an SD card on which data has been written many
times and the data writing speed has reduced, the recording
may suddenly stop during motion picture recording.
# Use a card recommended as suitable for motion picture
recording. (l 22)
If the recording stops even when a suitable SD card is used,
back up the data on the card to a computer, etc. and then format
the card. (l 75)
Problem Check points
LSQT1190(ENG).book 114 ページ 2007年1月13日 土曜日 午後3時32分

Table of Contents

Related product manuals