14
VQT3E89
The unit is in the standby condition when the AC adaptor is connected. The primary circuit is
always “live” as long as the AC adaptor is connected to an electrical outlet.
≥ The battery will not be charged if the power is turned on.
≥ It is recommended to charge the battery in a temperature between 10 oC to 30 oC.
(The battery temperature should also be the same.)
1 Connect the AC adaptor to this unit’s DC input terminal.
2 Connect the AC cable to the AC adaptor, then the AC outlet.
≥ For the AC cable, plug in 2 and then 3.
≥ The status indicator A will flash red at an interval of 2 seconds, indicating that charging
has begun.
Charging the battery
When this unit is purchased, the battery is not charged. Charge the battery before
using this unit.
SDRS71&H101GN-VQT3E89_mst.book 14 ページ ２０１０年１２月２日 木曜日 午後３時３５分
To Next Page
Loading...
