Panasonic SG-J500 (K) - Tape and Phono Adjustments

MEASUREMENTS AND ADJUSTMENT
ae AZIMUTH ALIGNMENT
Test equipment connection is shown in figure.
. Playback test tape QZZCAC. (10 kHz, —20 dB) Speaker
. Adjust screw ® for maximum indication for equal output Terminals
on both channels.
_ After alignment, lock the head adjust screw @ with
lacquer.
VTVM OSCILLOSCOPE
ERASE BIAS ALIGNMENT
1. Test equipment connection is shown in figure.
2. Place unit into TAPE position.
3. Place cassette deck into recording mode. a
4. Adjust VR803 for 10.5V +0.5V on VTVM.
(TP801)
(TP802) o
KN Blade
‘Screwdriver
TAPE DECK SERVICE AID
When the cassette tape is caught around the capstan
shaft:
Remove 7 screws on the cabinet, and open the front panel,
then turn the flywheel counterclockwise.
Front Panel