Panasonic SY-PA100 - Editing Chord Progressions; Inputting New Chord Progressions; Editing Measure and Beat Points; Editing Eighth Note Increments

(Step 1)
Remove the front panel mounting screws (A x 3) (refer to Figure-16 ).
(Step 2)
Remove the GUITER/MIC jack and the PHONE jack fixing nuts, and remove the JACK3 P.C.B.
(refer to Figure-16 ).Nuts
Figure-16
6.9. Removing the Jack1, 2 P.C.B.
- Follow the item 6.1.
(Step 1)
Remove the rear panel mounting screws (A x 7) (refer to Figure-17 ).
(Step 2)
Remove the INPUT jack and the LINEOUT1 jack fixing nuts, and remove the JACK1 P.C.B. (refer
to Figure-17 ).
(Step 3)
Remove the FOOT SW jack fixing nut, and remove the JACK2 P.C.B. (refer to Figure-17 ).
Figure-17
15