17
INSTALLATION AND SET---UP
The first available channel will be
displayed.
Switch the VCR test signal ’Off’.
Programme
change
Volume
adjust
5
Choose the desired language from the
OSD language selection.
Press TV/AV button to start ATP.
3
TV stations will be located and stored ready
for use.
4
ATP
02 99 : 21
CH02
41
OSD Language
PL CZ RO
HRU GB
--- / + : A d j u s t
TV/AV : Start ATP
N:Exit
The TV stations will be stored in the order that
they have been found, if the order is not to your
preference it can be r earranged. Refer to the
Tuning menu Swap feature --- see page 20 for
details.
1
CH41
IT IS IMPORTANT that you only use TV programme position ‘0’ to view your VCR. If your VCR picture does not appear on
programme position ‘0’ (the VCR position), it will be necessary to either adjust the RF channel of the VCR or to adjust the tuning of
the TV’s programme position ’0’ until the RF output of the VCR is received.
To Next Page
Loading...
