Panasonic TC-P42S2

Auto channel setup (ANT/Cable setup)
Select the connected Antenna in terminal
Not used: Go to Q
(Labelinputs)
Select "Not used" when no wire is connected to the "Antenna/Cable" terminal.
® Typical when a Cable/Satellite box is connected to a TV input.
® Prevents accidental tuning to an unavailable signal.
_2_Select "Start"
Skip: Go to
(Labelinputs)
Start scanning the channels
(Availablechannels areautomaticallyset.)
@
-13
B
(D
O3
(D
t-
• Press to return to
the previous screen
RETURN
@
Complete the Auto program setup
Completion message is displayed when the Auto program scan is successfully
completed.
If there is no available
channel, return to @ - _1_
(ANT/Cable setup).
"Not used" will be selected.
• Operation of the EXIT button during "First time setup"
Press the button once to display confirmation screen. Press again to close
confirmation screen.
[EXIT confirmation screen]
Yes _ Exit "First time setup"
No _ Return to the original screen.
15