38
i ing and Setting Channels
The current channel settings can be changed according to your needs and reception
conditions.
Display menu
MENU
Select "Setup"
Select "ANT/Cable setup"
ANT/Cable setup
Select the function
[] Press to exit from
a menu screen
EXIT
Set
[]To reset the settings of setup menu |
Select "Reset to defaults" in Setup menu (@)_and |
press OK /
@ Input your 4-digit password with number buttons
Automatically searches and adds available channels to the memory.
_ Select "ANT in" _3_Select a scanning mode (p. 18)
_, Select Cable or Antenna
Or select "Not used" (p. 17). _2_ok
_2_Select "Auto program"
select
Settings are made automatically
® After the scanning is completed, select "Apply"
(see below (_)).
® All previously saved channels are erased.
Use this procedure when changing the channel setup or
changing the channel display.
Also, use this to add or skip channels from the channel
list manually.
You can select a channel tuning mode (Digital only/
Analog only) in "Channel surf mode"(p. 29)
(i_ Select "Edit"
_2_Select the item to be edited
Caption Add Changes the station identifier
Favorite:
Registers channel to Favorite
List
_ Add:
R G Adds or skips channels
_ roceed to
next page
Go back to previous page
Edit
_ Caption
Caption
set/next
D_B
DBB
or
HDU
B
Select or edit the station identifier.
(maximum 7 characters available)
® Favorite
Set favorite I Select the number
® Add RETURN
Press OK to select "Yes (add)" or "No (skip)"
@ Move cursor to channel number
@ Select "Apply"
To cancel the Edit
Check the signal strength if an interference is found or freezing occurs on a digital image.
D _ Q .........., _ If the signal is weak, check the antenna.
DBB
,qbchange If no problem is found, consult your local dealer.
UDm or
channel
intensity ® Not available if "Cable" is selected in "ANT in"
(see above).
® Available only for digital antenna channels.
®;If "Lock" (p. 36) is activated and "ANT/Cable setup" is selected, "Enter password." will be displayed.
®
m
o_
5"
t.Q
tm
CO
G)
t.O
©
G)
O0
39