Panasonic TC-P50C1

irst Time etup
"First time setup" is displayed only when the TV is turned on for the first time after the power cord is
inserted into a wall outlet and when "Auto power on" (p. 28-29) is set to "No".
Turn the TV On with the POWER button
POWER
or
(TV)
* This setting will be skipped next time if you select "Home Use",
_1_Select your language
_2_Be sure to select "Home Use"
® Please confirm your selection (Home Use) before pressing OK button.
[] If you select "Store" by mistake in _z_",confirmation screen will be
displayed.
® Select "No" and return to previous screen 12_,.
® If you select "Yes", Screen enters store demonstration mode.
To display the "Please select your viewing environment" screen again as
shown above and select "Home Use", do one of the following:
• Press and hold down the front POWER button.
• Unplug the TV and plug it again.
[] Press to exit from
a menu screen
EXIT
[] Press to return
to the previous
screen
RETURN
@
[] Press to exit from
a menu screen
EXIT
® To change setting
(Language/Clock/
ANT/Cable setup/
Input labels) later, go
to Menu screen
(p. 28)
@next
_select
item
Year: Select the year
Month: Select the month
Day: Select the day
Hour: Adjust the hour
Minute: Adjust the minute
Auto channel setup
_ Select "ANT/Cable setup"
_2_next
0_select
Select "ANT in"
@set
Cable: Cable TV
Antenna: Antenna
_select Not used: Skip TV tuning
_ go to Q
Select "Not used" when no wire is connected to the "Antenna/Cable" terminal.
_ Typical when Cable/Satellite box is connected to a TV input.
® Prevents accidental tuning to an unavailable signal.
_3_Select "Auto program"
@next
_select
®
77
_-!.
3
G)
03
16 17