Slide 70
TV Data Copy to USB Drive
Quick Procedure to Copy the TV’s Data to a USB Drive.
Slide 70
The following data can be copied from the TV to an USB Drive:
• User settings data (Including hotel mode setting data).
• Channel scan data.
• Adjustment and factory preset data (A board replacement only)
This will help to restore the customer’s settings when the A board is replaced for a non-shutdown issue.
This also allows for the hotel data on a TV to be copied to several TVs.
1. -A start-up .pwd file has to be created on an USB Drive so the TV data can be saved on the USB
Drive. (Do this on a PC or Laptop).
a) – Create a file named “board_replace” if transferring the data from a TV which A board is being
replaced.
b) – Create a file named “hotel” to copy the hotel data.
2. -Originally, the file is created as “.txt” and then converted to “.pwd”. (Different methods can be used
to create .txt files and convert them to .pwd).
3. - The USB Drive has to then be connected to the TV.
4. - A predetermined password has to be entered, depending on the type of data that will be copied on
the USB Drive:
• Enter 2770 for A board replacement.
• Enter 4850 for Hotel data.
5. After the data from the TV is copied to the USB Drive, a new folder is created on the USB Drive:
• Board_replace
• Hotel.
6. The data from the USB Drive can now be copied to a TV of the same model.
Procedure to copy the data from the TV to the USB.
To Next Page
Loading...
