Troubleshooting 2 Blinks Failure (TC-P50ST50)
Yes
Place the positive lead of a voltmeter at pin 13
of connector P6 while the black lead is
connected to ground (Chassis ground). Plug in
the TV and turn it on
No
Does 15V
appears
momentarily
on pin13 of
CN P6?
Start Here
Replace the A
board
Replace the P
board
List of boards likely to cause this
symptom.
Blink
Code
No.1 No.2 No.3 No.4
2 Blinks P A
Slide 10
Find information for TC-
P50UT50 on the next slide)
To Next Page
Loading...
