2. Remove 4 screws and then remove SC2-Board.
6.21. Removal of S1-Board
1. Remove the Customer Control Unit.
(Reference to Removal of the Side Angle (L), (R))
2. Remove 2 screws (R).
3. Remove 1 screw (S).
4. Disconnect a connector (S34) and then remove S1-Board.
6.22. Removal of SS2-Board
1. Remove the Side Angle (L).
(Refer to Removal of the Side Angle (L))
2. Remove 6 screws and then remove the Reinforcement
Plaste (E).
3. Remove the flexible cables from the connectors (SS51,
SS52, SS53, SS54).
4. Disconnect the connectors (SS29, SS30, SS31, SS32).
5. Remove 6 screws and then remove SS2-Board.
23
TH-103PF9UK / TH-103PF9EK
To Next Page
Loading...
