Panasonic TH-103PF9EK - 12 Troubleshooting Guide

12.1.1. Display Indication
1. Self-check is used to automatically check the bus line
controlled circuit of the Plasma display.
2. To get into the Self-check mode, press the volume down
button on the customer controls at the side of the set, at the
same time pressing the OFF-TIMER button on the remote
control, and the screen will show.
If the CCU ports have been checked and found to be incorrect.
Or not located then " - - " will appear in place of " OK ".
“ 01 “ in the line of the “ PTCT ” means the number of blinks of
the Power LED is 1. (Reference to 11.1.2)
“ H09 “ in the line of the “ PTCT ” is the error code.
Note:
The line of the “ PTCT ” displays when you get into the Self-
check mode for the first time only after the Power LED
blinks.
12 Troubleshooting guide
12.1. Self Check
70
TH-103PF9UK / TH-103PF9EK