Panasonic TH-152UX1 - Connections; Video Equipment Connection

7
Connections
Video equipment connection
1
2
Pass the attached cable
 xing band through the clip
as shown in the  gure.
To secure cables connected to Terminals, wrap the cable  xing band around them
then pass the pointed end through the locking block, as shown in the  gure.
While ensuring there is suf cient slack in cables to minimize stress,  rmly
bind all cables with the supplied  xing band.
To tighten: To loosen:
Pull
Pull
Push the catch
Cable  xing
Secure any excess cables with band as required.
Note:
Three  xing bands are supplied with this unit. In case of securing cables at six positions, please purchase it separately.
SDI IN 1-4 (4 systems)
4k2k signal Dual Link
HD-SDI input terminal
(see page 8)
PC IN
PC Input
Terminal
(see page 11)
SERIAL
Control the Plasma
Display by connecting
to PC. (see page 12)
AV IN (HDMI 1/2)
HDMI Input Terminal
(see page 10)
SLOT (DVI-D IN)
DVI-D Input Terminal (equivalent of DVI-D Terminal
Board (TY-FB11DD)) (see page 10)
It accepts the Terminal board (optional accessories).
(see page 1)
3D SHUTTER OUT
Connect the 3D IR
TRANSMITTER
(optional accessory).
DVI-D IN 1-4 (4 systems)
4k2k signal Single Link
DVI-D input terminal
(see page 9)