VHF, UHF and Cable TV I
VHF and UHF
Power switch
ACTION
(Press to make
selections.)
INPUT button
(Change to input
signal.)
Remote control sensor
Operation can be done
from the TV set.
• Channel selectors
• Volume adjusters
C.AT.S sensor
Plasma C.A.T.S (Contrast Automatic Tracking System)
Plasma C.A.T.S automatically senses the ambient light
conditions and adjusts the brightness and gradation accordingly,
to optimise contrast.
(Effective when Picture mode is set to Auto.)
EXIT PAGE GUIDE
® ® ®
® ® ®
® ® ®
R-TUNE PROG
o ® ®
nEW pLAy
r_l _ r_q
PAUSE STOP REC
ciB_
FREEZE PIP CH SEARCH
TVNCR VCR CH OPEN/CLOSE
O (Z) (E) G)
PIP SPLIT MOVE SWAP
0000
z'N
(_ Press _._,Z"to the TV set with the remote
operate
control.
2
Press to turn the TV on (See page 19).
3 Press to select the desired channel.
Select the desired volume level.
Notes:
(1) The channel number and volume level remain the same even after
the TV is turned off.
(2) Power consumption and howling sound can be reduced if the volume
level is lowered.
2O
To Next Page
Loading...
