23
TH-42LF6W_TH-42LF60W
7 Disassembly and Assembly Instructions
7.1. PCB Layout
7.2. Preparation
Please pull soft cloth etc. not to damage a screen and please
turn the front of a main part down and lay it down
7.3. About disassembly and
replacement
Cautions when replacing each component
-When you replace each component, please be sure to
carry out according to the following procedure.
-When you attach each module, please do not bolt a screw
strongly.
-The part without the statement of tightening torque, please
tighten a screw 50 - 70 [N cm].
-To disassemble P.C.B., wait for 1 minute after power was
off for discharge from electrolysis capacitors.
-When tightening a screw, retention structures are required
not to deform the LCD Panel.
-Please remove a clamper and a wire processing tape if
needed in the repaire.
-Hold the specified parts to stand the monitor up. (Prevent
from the curvature and deformation of a set)
To Next Page
Loading...
