59
Using Web Browser Control
please check Network Setup under the Setup of the unit. (see page 48)
Notes:
To use a DHCP server, make sure the DHCP server is
started.
During a DHCP server is used, IP ADDRESS,
entered.
When the set values are changed properly,
changed set items are displayed.
Item Details
DHCP
Set to ON when a DHCP server is
used, or OFF when it is not used.
IP ADDRESS Enter an IP address.
Enter a subnet mask.
GATEWAY Enter a gateway address.
PORT
Enter the port number used for
command control. The available
setting range is 1024 - 65535.
LAN SPEED
Set the connection speed of the
LAN environment.
Set the ID to identify this unit. The
available setting range is 0 - 99.
SAVE Save the each set value.
Password Setting (Password Setup Screen)
Click CHANGE PASSWORD from the menu. Password to access the Web browser control can be set. When the
password is changed in this screen, the password used for command control and the PJLink™ security authentication is
also changed.
Notes:
The default password is “panasonic”.
Up to 32 alphanumeric characters can be used for a
password.
When the password is changed properly, “Password
has changed.” message is displayed.
Item Details
OLD
PASSWORD
Enter the old password.
NEW
PASSWORD
Enter the new password.
NEW
PASSWORD
(RETYPE)
Enter the password entered in “NEW
SAVE
Save the new password. The
To Next Page
Loading...
