Panasonic th-42lf80w - Page 61

61
English
Setting conditions
The following table describes restrictions (available
combinations) on each setting item.
Main
HDMI1
HDMI2
DIGITAL
LINK
*
1
DVI-D
PC
COMPONENT
*
2
VIDEO
USB
Backup
HDMI1
HDMI2
DIGITAL LINK
*
1
DVI-D
○ × ×
PC
COMPONENT
*
2
VIDEO
× × ×
USB × × ×
○:SelectableforbothPrimaryandSecondary.
×: Not selectable for neither Primary nor Secondary.
*
1: [DIGITAL LINK] is for LF80 series only.
*
2: [COMPONENT] may be displayed as [RGB]
depending on the settings of [Component/RGB-in
select]. (see page 44)
Recall display
Pressing <RECALL> displays any of the followings.
●
When the main input is being used for viewing and
the operating condi ions for the Backup Input function
are met.
HDMI1
16:9
Main input
Backup OK
●
When the backup input, enabled by the operation of
the Backup Input function, is being used for viewing.
HDMI1
16:9
Backup Input
DVI
When the conditions for the Backup Input function
are met
Main input
Backup OK
■ Backup input (Normal)
Switches to he backup input if an interruption of
video occurs.
Note
●
When an analogue (PC, COMPONENT or VIDEO)
input is being used for viewing, you cannot set an
analogue (PC, COMPONENT or VIDEO) input as a
backup input.
●
Any analogue (PC, COMPONENT or VIDEO)
input cannot be set as [Primary backup input] or
[Secondary backup input].
●
This function will start opera ing once a video signal
is detected by both the input in use for viewing and
the backup input and the [Status] item is displayed
as [Active].
[Primary backup input]
Sets the first priority backup input.
(None) / [HDMI1] / [HDMI2] / [DIGITAL LINK]
*
1
/
[DVI-D] / [PC] / [COMPONENT]
*
2
/ [VIDEO] / [USB]
The input that is of the same type as the one in use
for viewing will be greyed out.
When an analogue (PC, COMPONENT or VIDEO)
input is being used for viewing, you cannot set an
analogue (PC, COMPONENT or VIDEO) input as a
backup input.
Any analogue (PC, COMPONENT or VIDEO)
input cannot be set as [Primary backup input] or
[Secondary backup input].
[Secondary backup input]
Sets the second priority backup input.
(None) / [HDMI1] / [HDMI2] / [DIGITAL LINK]
*
1
/
[DVI-D] / [PC] / [COMPONENT]
*
2
/ [VIDEO] / [USB]
The input that is of the same type as the one in use
for viewing will be greyed out.
When an analogue (PC, COMPONENT or VIDEO)
input is being used for viewing, you cannot set an
analogue (PC, COMPONENT or VIDEO) input as a
backup input.
Any analogue (PC, COMPONENT or VIDEO)
input cannot be set as [Primary backup input] or
[Secondary backup input].