8 Self Check
1. Self-Check is used to automatically check the bus lines and hexadecimal code of the TV set.
2. To get into the Self -Check mode press the Down (
) button on the customer controls at the front of the set, at the same
time pressing the Status button on the remote control, and the screen will show :
If the CCU ports have been checked and found to be incorrect or not located then “--” will appear in place of “O.K.”.
Display Ref.No. Description Board
MEM IC1107 EEPROM DG-Board
GC4P IC4054 Global Core Processor DG-Board
GC3FS IC4013 Global Core for Sub DG-Board
HAD IC4012 OSD RGB A/D DG-Board
AVSW1 IC2105 Video SW H-Board
AVSW2 IC3005 Audio SW H-Board
Tun1 TU001 Tuner TA-Board
VIF - - -
DAC1 IC1106 Ext. DAC DG-Board
DAC2 IC1116 Ext. DAC DG-Board
DAC3 IC3006 Ext. DAC H-Board
DAC4 - - -
MSP IC2106 Multi Sound Processor H-Board
SOUND IC2300 Sound Control Z-Board
PANEL IC9003 Convert Micom D-Board
SDM SD-Module MPEG4/PHOTO view, SD recording SD-Module
HDMI IC5003 HDMI I/F Reciever DV-Board
ADV IC4005 10bit A/D DG-Board
33
TH-42PV500E / TH-42PV500B / TH-37PV500E / TH-37PV500B
To Next Page
Loading...
